Molded Chicken

Total Time:
2 hr
Prep:
2 hr

Yield:
1 chocolate chicken
Level:
Advanced

CATEGORIES
Ingredients
  • Cocoa butter, melted
  • Various powdered food coloring
  • 8 ounces bittersweet chocolate, tempered
  • 48 ounces white chocolate, tempered
  • Special Equipment, see source link for information:
  • Chicken mold
Directions

Make some "paint" by mixing the cocoa butter and a small amount of powdered food coloring. Make a few colors. It will be easier if you use yogurt machine to store and warm your paints. Use a paintbrush to paint the inside of the mold, applying color where you are inspired to do so (eyes, beak, etc.).

Using the paintbrush, very lightly paint the bittersweet chocolate into the feathers of the chicken. Using a ladle, fill the mold with white chocolate. When it is full, empty the excess chocolate back into the bowl. The inside of the mold should be evenly coated. Wipe the lip of the plastic mold clean and place the mold upside down on a wire rack over a sheet pan. Repeat with the other half of the mold. Once the chocolate starts to harden, about 5 minutes, scrape the lip of the mold clean again with a paring knife. It is important to do this because when the chocolate sets, it shrinks or retracts from the sides of the mold. A clean edge will keep it from sticking and cracking as it shrinks. You can place the mold in the refrigerator for several minutes to help the chocolate harden.

If the chocolate is properly tempered, it will easily release from the mold. To unmold, rest your thumbs on the outside, and place your first two fingers on the inside and gently begin to lift the chocolate from the mold. Do not press or pull too hard, or you will break it. You will need to apply this lifting pressure to each side to loosen the chocolate from the mold. Glue the 2 halves of the chicken together with melted chocolate.

How to Temper Chocolate(From Dessert Circus, Extraordinary Desserts You Can Make At Home by Jacques Torres):

Chocolate is tempered so that after it has been melted, it retains its gloss and hardens again without becoming chalky and white (that happens when the molecules of fat separate and form on top of the chocolate). There are a variety of ways to temper.

One of the easiest ways to temper chocolate is to chop it into small pieces and then place it in the microwave for 30 seconds at a time on high power until most of the chocolate is melted. Be very careful not to overheat it. (The temperature of dark chocolate should be between 88 and 90 degrees F, slightly warmer than your bottom lip. It will retain its shape even when mostly melted. White and milk chocolates melt at a temperature approximately 2 degrees F less because of the amount of lactose they contain.) Any remaining lumps will melt in the chocolate's residual heat. Use an immersion blender or whisk to break up the lumps. Usually, chocolate begins to set, or crystallize, along the side of the bowl. As it sets, mix those crystals into the melted chocolate to temper it. A glass bowl retains heat well and keeps the chocolate tempered longer.

Another way to temper chocolate is called seeding. In this method, add small pieces of unmelted chocolate to melted chocolate. The amount of unmelted chocolate to be added depends on the temperature of the melted chocolate, but is usually 1/4 of the total amount. It is easiest to use an immersion blender for this, or a whisk.

The classic way to temper chocolate is called tabliering. Two thirds of the melted chocolate is poured onto a marble or another cold work surface. The chocolate is spread out and worked with a spatula until its temperature is approximately 81 degrees F. At this stage, it is thick and begins to set. This tempered chocolate is then added to the remaining non-tempered chocolate and mixed thoroughly until the mass has a completely uniform temperature. If the temperature is still too high, part of the chocolate is worked further on the cold surface until the correct temperature is reached. This is a lot of work, requires a lot of room, and makes a big mess.

A simple method of checking tempering, is to apply a small quantity of chocolate to a piece of paper or to the point of a knife. If the chocolate has been correctly tempered, it will harden evenly and show a good gloss within a few minutes.

YOU MIGHT ALSO LIKE
Loading review filters...
BROWSE REVIEWS BY KEYWORD
    Flag as inappropriate

    Thank you! your flag was submitted.

    Not what you're looking for? Try:

    Chicken Salad

    Recipe courtesy of Food Network Kitchen