Royal Icing

Name: Royal Icing
Prep time: P0Y0M0DT0H10M0.000S
Total time: P0Y0M0DT0H10M0.000S
Yield: 2 cups
Cuisine: french
Ingredients: 1 large egg white*; 1 1/2 cup powdered sugar; 1/2 lemon, juiced and strained; How to make a cornet, method follows

Getting reviews...

Level: Easy
Total: 10 min

Prep: 10 min

Yield: 2 cups

Level: Easy
Total: 10 min

Prep: 10 min

Yield: 2 cups

Ingredients

Deselect All

1 large egg white*

1 1/2 cup powdered sugar

1/2 lemon, juiced and strained

How to make a cornet, method follows

Directions

To make royal icing: Combine the egg white and powdered sugar in a medium-size mixing bowl and whip with an electric mixer on medium speed until opaque and shiny, about 5 minutes. Add the lemon juice and continue whipping until completely incorporated, about 3 minutes. The lemon juice whitens the royal icing. The royal icing should be light, fluffy, and slightly stiff. You may need to adjust the consistency by adding more egg whites if the icing is too dry or more powdered sugar if it is too wet.
Place the royal icing in a small piping bag or paper cornet.
The Cornet: A cornet is a small piping bag made from parchment paper. It is usually used to make fine decorations.
Cut an 8-by-12-by-14 1/2-inch triangle from a sheet of parchment paper. Hold the middle of the long side of the triangle between two fingers of 1 hand. Take the tip of the triangle on the short, wide end and roll it toward the other tip of that same end while simultaneously pulling it in an upward motion. The tip of a cone will form where your thumb and finger hold it on the long side.
Release your grip from the long side, so that you are now holding the 2 corners where they meet. The paper will already resemble a partially formed cone. Roll the remaining tail until it is completely rolled into a cone. There will be 1 point sticking up from the open end. Fold it inside toward the center, and crease the fold. Now you should have a cornet. To close the cornet once it has been filled, fold it away from the seam; this will keep the seam from opening. Use a pair of scissors or a sharp paring knife to cut an opening at the tip of the cornet to the desired size.