Chocolate Pumpkin Candy Dish

Total Time:
1 hr
Prep:
1 hr

Yield:
1 pumpkin candy dish, and 4 do
Level:
Advanced

CATEGORIES
Ingredients
  • 32 ounces white chocolate, tempered
  • Powdered food colors
  • 8 ounces cocoa butter, melted
  • 16 ounces bittersweet chocolate, tempered
  • Special equipment, See source link for information:
  • Halloween transfer sheet
  • 3 -dimensional pumpkin dish mold
Directions

Make the pumpkin candies: Fill a piping bag with tempered white chocolate. Fill each pumpkin cavity with the chocolate and allow it to set. You can place the mold in the refrigerator for 10 to 15 minutes to help the chocolate to harden. When set, the pumpkin candies should pop out of the mold. You can serve them as they are or you can sandwich 2 together. To sandwich them together, pipe a little of the white chocolate on the back of 1 piece and press another candy back-to-back. Let the chocolate harden.

Make the pumpkin candy dish: Place some powdered orange food color in a small bowl. Add a few tablespoons of cocoa butter to the food color and stir until well combined. Use a pastry brush (or a clean pastry brush used only for food, not for paint) to paint the inside of the mold (top and bottom) with the color. Make sure the inside is completely coated. You can use a hairdryer to warm up the cocoa butter paint if it begins to cool. Place the mold in the refrigerator for a few minutes until the cocoa butter sets.

Use a cornet filled with bittersweet chocolate to pipe the chocolate into the stem at the top of the mold. Allow the chocolate to set.

When the painted mold has set, use a ladle to completely fill each piece (the top and the bottom) of the mold with white chocolate. Tap the mold on the counter to encourage the air bubbles to depart. When the mold is full, empty it into the bowl of chocolate. The inside of the mold should be evenly coated with chocolate. Scrape the mold clean with an offset spatula and place it upside down on a wire rack placed over a baking sheet. It may be necessary to give each mold more than one coat. This will make the candy dish stronger. Once the chocolate starts to harden, about 5 minutes, scrape the edge clean with a chef's knife. When the chocolate sets, it shrinks or retracts from the sides of the mold. A clean edge will keep it from sticking and cracking as it shrinks. You can place the mold in the refrigerator for several minutes to help the chocolate to harden. Repeat with as many molds as you would like to make.

Unmold the pumpkin candy dish. It should pop out of the mold. Fill the bottom of the mold with pumpkin candies. Place the top of the mold in place.

Whenever I use cocoa butter mixed with food color, I like to use an electric yogurt maker. The yogurt maker will keep the cocoa butter melted. Leave the "paints" in the yogurt maker at the end of your project. When you are ready for the next project, just plug in the yogurt maker and, in 60 minutes, you are ready to go.

The pumpkin candies are made with a special Halloween transfer sheet. It is 3-dimensional and you will need to purchase it before you begin. You will also need to purchase the 3-dimensional pumpkin dish mold.

YOU MIGHT ALSO LIKE
Loading review filters...
BROWSE REVIEWS BY KEYWORD
    Flag as inappropriate

    Thank you! your flag was submitted.

    Not what you're looking for? Try:

    Pumpkin Chocolate Chip Cookies